Antari HZ-500 - Manual (Page 7)

7
Do not wipe it directly when the cap is attached on the tank. By doing this you can avoid the dust
fall ing into the fluid tank and contaminate the haze liquids.
5. Please do not allow magnetic equipment to be close to the haze outlet door of the hazer. Magnetic
equipment could cause wrong action of the door sensor.
Control Panel Operation
The built-in control panel on the rear of the machine features an LCD panel displaying all operation
statuses of the haze machine. The control panel allows the user to customize functions by adjusting the
fogging duration and interval as well as the DMX address and the door sensor. There are six buttons on
the control board. All current operating parameters are automatically stored in non-volatile memory,
allowing the machine to be powered down without losing function settings. The control buttons are:
FUNCTION, Up, Down, TIMER, VOLUME and MANUAL. You can program the necessary menu settings
with the control panel when the display indicates »Ready To Haze«.
After switching on, the display shortly indicates »Antari Hz-500« and is ready for haze output. The display
indicates »Ready To Haze«.
-Continuous operation
When the machine is ready for haze output, short actuation of the button VOLUME activates continuous
haze output. The display indicates »Working«. To stop the haze output, press the button VOLUME once
again.
-Manual operation
For immediate haze output, keep the button MANUAL pressed. The display indicates »Working«. As soon
as you release the button, the haze output will stop. The manual operation will take priority over the
continuous operation and the timer operation. Even if one of these operating modes is activated, the haze
machine will always emit haze when the button MANUAL is pressed.
-Timer operation
In the timer mode, the haze machine will automatically emit haze. The time intervals, duration and haze
volume depend on the corresponding menu settings. Press the button TIMER, to activate the timer mode.