Antari Z-1200II - Manual (Page 9)

9
* Transmitter:
With the transmitter it is possible to emit fog via radio over a distance of up to 50 meters. The transmitter is
compatible to any receiver of the Z-30PRO and can control an unlimited number of machines in parallel.
Press the button “A”, to emit fog. The button “A” has the same function as the button VOLUME on the control
panel, i.e. the fog output depends on the setting of menu item »Volume Out«. The display indicates »Volume«
followed by the defined value or »NON STOP BURST« when continuous fog output was selected. To stop the
fog output, press the button “B”.
* Receiver:
The receiver is tested and pre-attached to the panel of each Z-30PRO. Please do not try to remove it. The
receiver responds to up to 5 different transmitters that are registered with the machine. The included transmitter
has been registered to the machine before shipment. It can be directly operated without any start-up setting.
-Registering transmitters
To operate the machine with a different transmitter than the included one, or to operate it with up to 5 different
transmitters, each transmitter must be registered first. For this purpose, turn on the machine. When the display
indicates »Wireless Setup«, press the button “A” 1 second on each transmitter. Thus the previous transmitters
are cleared from the memory of the receiver. The setting must be completed within 15 seconds after switching
on the machine. Then the machine will automatically exit the transmitter setting mode. The display shows
»Wireless Setup OK«. At this point, no further transmitter can be added.
If no transmitter is registered when the machine is switched on, the memory of the receiver will keep the record
of the previous operation.
Setting Example 1:
In order to register several transmitters with a machine, turn on the machine. When the display indicates
»Wireless Setup«, pres
s the button “A” 1 second on each transmitter within 15 seconds to establish the signal
transmission.
Setting Example 2:
In order to use 1 transmitter to control 2 or more machines, turn on the machines respectively. When the
displays indicate »Wireless
Setup«, press the button “A” 1 second on the transmitter within 15 seconds to
establish the signal transmission.