Antari Z-1200II - Manual (Page 10)

10
-Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted and must be replaced. For this
purpose, take off the housing cover and remove the used battery. Insert a fresh DC 12V battery as indicated in
the battery compartment and refit the housing cover.
5B
Switching the wireless function on and off
Press the button FUNCTION until the display indicates »Wireless On«. Use the buttons UP and DOWN to
deactivate the wireless function (indication »Wireless Off«) and to reactivate it (indication »Wireless On«).
￭
Note: When warming-up process is completed and wireless function is activated the LCD screen indicates
“Ready To Fog W”. (“W” means Wireless) On the contrary, when the wireless function is deactivated the
LCD screen shows “Ready To Fog” (Without “W”).
Performance Note
￭
All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when installing
your unit.
￭
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so
after being turned off.
￭
All fog machines have a recycling period after long bursts when the machine will shut itself down for a
short period in order to heat up again. During this time no fog can be produced.
Cleaning and Storage
Cleaning your fog machine regularly can help you reduce the frequency of parts replacement and the cost of
maintenance.
After 2,000 hours operation, we suggest you use distilled water to clean the heater as following steps:
1. Fill proper distilled water into a clean tank and connect the fluid tube of the fog machine to the tank.
2. Run the fog machine in a well ventilated place until the tank is empty.
3. Use dry cloth to wipe the fog machine.
If the fog machine is not in use, please clean it before storage. Store the fog machine in a dry and cool place. At
least run the fog machine once a month.