American Diagnostic Corporation (ADC) Prosphyg 790 - Manual (Page 6)

Manometer Quality Control
A Serial number and Lot number are automatically as-
signed to every aneroid during manufacturing, ensuring
every item is "controlled".
The Serial Number can be located on the faceplate of
each aneroid (Figure 4).
The Lot number is located on the box end label (Figure
5).
Standards
ANSI/AAMI/ISO 81060-1:2007 • EN/ISO 81060-1: 2012
Disposal
When your sphygmomanometer has reached its end of life, please be sure to dispose of it
in accordance with all regional and national environmental regulations. Devices that have
become contaminated should be disposed of in accordance with all local ordinances and
regulations.
Symbol Definitions
The following symbols are associated with your aneroid sphygmomanometer.
LOT 0 00000 000
Lot Number
(Figure 4)
Serial Number
(Figure 5)
infect, first follow the cleaning steps above, then spray cuff with 10% bleach solution until
saturated, agitate with a sterile brush over entire cuff surface for five minutes. Rinse contin-
uously with distilled water for five minutes. Wipe off excess water with sterile cloth and
allow cuff to air dry.
CAUTION: Do not iron cuff.
CAUTION: Do not heat or steam sterilize cuff.
Symbol Definition
Important Warning/Caution
Latex-Free
Circumference Size
Conforms to EU Standards
Symbol Definition
Authorized European
Represenative’s Information
Manufacturer’s Information
Temperature Limit
Humidity Limitation
° F