Acura 2005 RSX - Owner's Manual - Manual (Page 40)

After confirming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.
To remove slack, it may help to
put weight on the child seat, or
push on the back of the seat while
pulling up on the belt.
A child seat with a tether can be
installed in either seating position in
the back seat, using one of the
anchorage points.
Push and pull the child seat
forward and from side to side to
verify that it is firmly secured
during normal driving maneuvers.
If the child seat is not secure,
unlatch the belt, allow it to retract
fully, then repeat these steps.
To deactivate the locking
mechanism and remove a child seat,
unlatch the buckle, unroute the seat
belt, and let the belt fully retract.
Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available.
4. 5.
CONTINUED
Installing a Child Seat with a
Tether
Installing a Child Seat
Dr
iv
er
and
P
asseng
er
Saf
e
ty
39
Main Menu Table of Contents