Acura 2007 TSX - Owner's Manual - Manual (Page 312)

Examine the new wiper blades. If
they have no plastic or metal
reinforcement along the back
edge, remove the metal
reinforcement strips from the old
wiper blade, and install them in
the slots along the edge of the new
blade. Remove the blade from the blade
assembly:
Find the side of the blade
labeled ‘‘LOCK.’’ This is the side
you pull out.
Pull back the end of the blade
assembly on the ‘‘LOCK’’ side of
the blade. Then grab the end of
the blade, and slide it out.
Install the new blade onto the
blade assembly:
Pull back either end of the blade
assembly.
Place the side of the blade not
labeled ‘‘LOCK’’ on the end of
the blade assembly, and slide
the blade onto the assembly
until it is fully installed.
Slide the wiper blade assembly
onto the wiper arm. Make sure it
locks in place.
Make sure the blade is completely
installed and that its edge is not
bunched up.
Lower the wiper arm down against
the windshield, the passenger’s
side first, then the driver’s side.
3. 4.
5.
6.
7.
8.
Wiper Blades
Ma
int
e
na
nce
309
BLADE
REINFORCEMENT WIPER BLADE
Main Menu Table of Contents