Panasonic NI-W810CS - Manual (Page 9)

A
CAUTION
Do not use the "Jet of Steam Button " until the Thermostat Operating Indicator Light turns
off after setting the Temperature Setting Dial to " Linen Hot water may leak from the
Soleplate and burns may result, and it may cause corrosion.
HOW TO USE THE "VERTICAL STEAM" FEATURE
To get better results when using vertical steam, hang
the garment on a clothes hanger. Curtains and drapes
may also be steamed once they're hung. Hold the iron
away from your body, close to but not touching the fabric.
Pull the fabric tight with your free hand and pump the
Vertical Steam Button (Jet of Steam Button) at 2-5 seconds
inten/als as you pass the iron over the wrinkled fabric.
AWARNING
' Never iron clothes on the body or point your iron at anyone when steaming.
■ Keep hands and body away from steam areas while using vertical steam feature.
SELF-CLEANING
With the self-cleaning feature you can flush out mineral residue from the steam generating
chamber and the steam vents, refreshing your iron each time for a longer steaming life.
It is very important to operate the self-cleaning feature after each steam ironing to prevent
mineral accumulations from hardening.
1. Check water level. Water level should be over half full.
When water level is less than half full, fill with water according
to the instructions in "HOWTO FILL WITH WATER".
2. Preheat at" Linen" setting (for about 1-2 minutes).
Make sure that the Steam/Dry Selector is in the Dry position.
3. Set the Dial to" Off" and remove the AC plug.
4. Hold the iron horizontally over the sink.
5. Pump the "Jet of Steam Button " quickly (at leasts
times per second) about 20-30 times.
6. While self-cleaning, tilt the iron up and down slowly to help clean
the entire inside and let the water drip out of the soleplate vents.
7. Check that all water and steam have completely stopped coming out of the soleplate
vents. After self-cleaning is finished, empty any remaining water from the Water
Reservoir by turning the iron upside down.
-9-