Electronic 3-way auto shut-off function, Awarning – Panasonic NI-W810CS User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8. Iron on a towel to remove any drops of water remaining on the bottom of Iron.
9. Allow the Iron to cool and store on Its Heel Rest. Never store an Iron on Its Soleplate or
with water In It.
10. If water still remains inside the Soleplate after self-cleaning operation, dry out the Iron by
setting the iron on the" Linen" setting, to vaporize the remaining water. After the iron is
dry, follow the instructions under" AFfER EACH USE ".
STAY CLEAN VENTS
(NI-W810CS/W750TS Only)
The built-in Anti Calcium System (Calc Cut) in the Water Resen/oir continuously reduces scale
build up in the vaporizing chamber of the iron.
This system makes It possible to use the steam function for a long period of time and prevents
steam vents from clogging.
ANT I-DR IP SYSTEM (AUTOMATIC WATER SEAL)
(NI-W810CS/W750TS Only)
This model has an Anti-Drip System. When the temperature of the Soleplate's surface drops
below 238°F(115’C), the valve for the vaporizing chamber in the iron automatically closes
and stops the water from flowing. This prevents hot unvaporized water from spewing out
from the soleplate when the iron has cooled down. With this System, it is unnecessary for
you to wait until the inside of the vaporizing chamber dries completely when you store the
iron.
NOTE:
It Is not a sign of malfunction when you hear a clicking sound.
This sound can be heard whenever this system Is activated.
ELECTRONIC 3-WAY AUTO SHUT-OFF FUNCTION
AWARNING
The Auto Shut-Off feature (or setting the thermostat to "Off") is not intended to take
the place of unplugging the cord. Disconnect the electric iron when not in use !
Even though the iron is unplugged, the soleplate is still hot. Be sure to rest the iron
on its heel, away from fabric.
1. When the iron is not moved with its Soleplate facing down or on its side for approx. 1 minute,
the iron will automatically shut off power to the heater.
2. When the iron is not moved on its Heel Rest for approx. 10 minutes, the Iron will automatically
shut off power to the heater.
3. To resume ironing and turn the iron back on, simply move the iron in any manner. If the iron
has been left in the auto shut off mode for more than 10 minutes. Allow the Iron to reheat
until the Indicator Light goes out.
NOTE:
The Auto Shut-Off System works regardless of position of the Temperature
Selector Dial.
-
10
-