How to use the "spray" feature, Note, How to use the jet of steam "feature – Panasonic NI-W810CS User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO USE THE "SPRAY" FEATURE
Note:
Before using the spray feature, check the fabric iabei for ironing instructions. Some fabrics
may become spotted or stained with moisture.
The spray feature is particuiariy heipfui for removing stubborn wrinkies and where extra
dampening is needed.
The spray may be used with steam or dry ironing.
LJ
1. Simpiy pump the Spray Mist Button when spray is desired.
If the spray doesn't work immediateiy, keep pumping
untii it does.
2. To get a finer spray, pump the Button repeatediy.
To get a more powerful spray, pump the Button
slowly. For best results, use a quick, full stroke.
HOW TO USE THE JET OF STEAM "FEATURE
The"Jet of Steam"feature provides extra steam which goes deep into the garment and
is helpful for removing stubborn wrinkles. The "Jet of Steam" feature operates properly
only in the " Linen" position of the Temperature Selector Dial when steam or dry
ironing (If used at lower setting, water spotting will occur because the iron is not hot
enough to change water to steam ). If you have not used the" Jet of Steam " feature
for a long time, it is necessary to clean the inside of the iron before using this feature
on any clothes to be ironed. Simply test the "Jet of Steam" feature several times
away from the ironing board and clothes to be ironed. This will prevent brown spotting
or water spotting on the clothes.
1. Fill the iron as described in " HOW TO FILL WITH WATER'
2. Position the iron vertically and be sure the Temperature
Selector Dial is set to" Off".
Plug the AC Power Cord into the electrical outlet.
3. Set the Temperature Selector Dial to the " Linen" position.
4. Preheat the iron until the Indicator Light goes out, usually
about 1 -2 minutes.
5. Simply pump the " Jet of Steam Button " when steam is
desired. Pump the " Jet of Steam Button " several times
at the beginning of each ironing session.
6. Allow at least 2-5 seconds between uses of the "Jet of
Steam Button " to prevent water spotting. Use a press
cloth if necessary.
-
8
-