Clarion DFZ675MC - Manual (Page 22)

Common Operations
26
DFZ675MC
English
Setting the TV diver
You can change the reception setting for the TV
antenna connected to the TV tuner.
1. Press the [A] button to switch to the adjust
mode.
2. Press the [ R] or [F] button to select “TV
DIVER”.
3. Turn the [ROTARY] knob and select “ON” or
“OFF”.
●ON:
Set the diver setting to ON.
●OFF:
Set the diver setting to OFF.
4. Press the [A] button to return to the previous
mode.
Selecting AUX IN sensitivity
Make the following settings to select the
sensitivity when sounds from external devices
connected to this unit are difficult to hear even
after adjusting the volume.
* The factory default setting is “MID”.
1. Press the [A] button to switch to the adjust
mode.
2. Press the [ R] or [F] button to select “AUX
SENSE”.
3. Turn the [ROTARY] knob and select “AUX
LOW”, “AUX MID” or “AUX HIGH”.
4. Press the [A] button to return to the previous
mode.
How to register/delete PIN
1. Press the [A] button to switch to the adjust
mode.
2. Press the [ R] or [F] button to select
“CODE ”.
3. Press the [ h] button.
* When registering: “ETRY 0000” appears.
* When deleting: “DEL 0000” appears.
4. Press the [DIRECT] buttons to input optional
PIN in 4 digits.
CAUTION
• Establish your PIN by combining numbers
from 1 to 6 as you like in 4 digits.
Do not forget your PIN, for you cannot
perform any further operation without your
PIN when you remove the battery for repair,
etc.
• Write down your PIN for the future use.
5. Press and hold the [ h] button for 2 seconds
or longer to enter the PIN.
Notes:
• When registering PIN is completed, the unit enters
the CATS mode.
If you input wrong number when deleting your PIN,
you cannot complete the operation. In that case,
the unit requests you to input the correct PIN.
6. Press the [A] button to return to the previous
mode.
Performing a system check
This function verifies the devices connect
through CeNET.
1. Press the [A] button to switch to the adjust
mode.
2. Press the [ R] or [F] button to select “SYS
CHECK ”.
3. Press and hold the [ h] button for 1 second or
longer to start the system check.
Triggered audio mute for cellular
telephones
This unit requires special wiring to mute the audio
signal automatically when a cellular telephone
rings in the car.
* This function is not compatible with all cellular
telephones. Contact your local authorized Clarion
dealer for information on proper installation and
compatibility.
AUX function
This system has an external input jack so you can
listen to sounds and music from external devices
connected to this unit.