A port c port b port, 3) plumb rough using appropriate fittings – Jaclo Thermostatic Valve, Rough - J-TH34 User Manual
Page 8
jaclo
industries | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133
JACLO.COM | PG 8
CREATED 5.2014
(3) PLUMB ROUGH USING APPROPRIATE FITTINGS
Diverter and Thermostatic valve are factory sealed, do not separate!
A. Plumb hot and cold inlets on thermostatic body. Part #’s: J-TH34. J-TH12, J-TH34-686, J-TH34-688,
J-THVC12. See Fig. 3
B. If using lower port on thermostatic body, a separate volume control is required. If not, port must be plugged.
See Fig. 3
C. Select diverter ports to be used. A, B, C and plumb with appropriate fittings. Note: Port B is not used with
the 2-way diverter, Part #’s: J-TH34-686, J-TH34-688, J-20686 and J-20688. See Fig. 3
Note: Two way diverter can be used as a single outlet and volume control by capping A or C port. Three
way diverter can be used as two way diverter by capping any single port or a volume control by capping
any two ports.
A Port
C Port
B Port
Hot
Inlet
Cold
Inlet
Figure 3
Extra Outlet requires volume
control or plug (not supplied)