beautypg.com

Jaclo Gosh Concerto - 1730 User Manual

Page 2

background image

jaclo

industries | 129 Dermody Street Cranford, NJ 07016

p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133

JACLO.COM
GOSH CONCERTO | PG 2

CREATED 5.27.10

PROBLEM

POSSIBLE CAUSE

SOLUTION

Insufficient water output

· Insufficient pressure in the plant

· Check the plant

· Input filters are clogged

· Clean input filters

· Cartridge filters are clogged

· Clean cartridge filters

· Spouts are clogged

· Clean aerator, showerhead, accessories

Only cold water comes out

· Hot & Cold water supplies are reversed

· Reverse the supply pipes

· Insufficient hot water temperature

· Check the plant

Water temperature does not

· Large difference between supply

· Balance supply pressures

correspond to selected temperature temperatures

· Calibrate cartridge again

Only hot or cold water comes out

·Thermostatic cartridge is blocked

· Check the plant

· Replace the cartridge

Difficulty adjusting the comfort

· Insufficient hot water temperature

· Check hot water availability

temperature

·Thermostatic cartridge is blocked

· Rotate the graduated knob towards

hot then cold a few times

· Replace the cartridge

Leak towards the spout

· Sealing gasket is faulty

· Replace ceramic cartridge

· Dirt deposited between sealing disks

· Replace ceramic cartridge

· Ceramic disks severely damaged by impurities · Replace ceramic cartridge

Water comes out of a spout while

· Impurities in the diverter gasket

· Disassemble, clean or replace diverter

the other spout leaks

WARNINGS:

THE DEVICE MUST BE INSTALLED ACCORDING TO THE POSITIONS OF THE
WATER SUPPLY: HOT ON THE LEFT AND COLD ON THE RIGHT

TO MAKE SURE THE THERMOSTATIC DEVICE WORKS PROPERLY, SUPPLY
PRESSURE MUST NOT BE LOWER THAN 14.5 PSI. FAILURE TO FOLLOW
INSTRUCTIONS WHEN INSTALLING WILL PREVENT MIXER FROM WORKING

LINES MUST BE THOROUGHLY FLUSHED TO AVOID DAMAGE TO THE TAPS

AND TO THE TECHNOLOGIC APPLIANCES INSTALLED.

A CENTRALIZED FILTER PROTECTS THE PLANT FROM IMPURITIES IN THE

WATER

SHOULD INPUT PRESSURE EXCEED 72.5 PSI, IT IS ADVISABLE TO INSTALL

A PRESSURE REDUCER IN ORDER TO KEEP THE DEVICES WORKING

PROPERLY

INSTALLATION