Hardy Enviro Bench Scales - Manual (Page 6)

Okidata 420 Form Printer
The Enviro™ Series should be programmed for Port 1 Output button, 9600 baud, 8 data bits, no stop bits,
and Hibusy.
To change Menu Settings:
SEL
EXIT
POWER
SHIFT
ALARM
LF
GROUP
Micro Feed
Down
FF/LOAD
Micro Feed
Up
ITEM
MENU
TEAR
SET
PARK
PRINT
QUIET
TOF
SEL
MENU
1. To enter MENU MODE, press and hold the SHIFT key while pressing the SELECT key. The
“MENU” legend will be illuminated while in the menu mode.
2. With the printer in the Menu Mode, press PRINT to print the complete menu. The current default
settings print out. It is recommended to use tractor fed paper.
NOTE: The printed menu selections are different for each emulation mode.
3. Press GROUP to select the relevant group that needs to be changed (the group is the left-hand
column on the Menu printout).
4. Press ITEM to select the relevant item within the selected group (the Item is the center column on
the Menu printout).
5. Press SET to cycle through the settings available for the item you want to change (the settings are
the right-hand column on the Menu printout).
6. Press and hold the SHIFT key while pressing the SELECT key exit the Menu Mode.
Note: If you turn off the printer before exiting the menu mode, any changes will be lost.
(group) (item) (set)
(press LINE FEED to change) (press FORM FEED to change) (press TOF SET to change)
Printer Control
Font
Font
Font
Font
Font
Font
Symbol Sets
Symbol Sets
Symbol Sets
Symbol Sets
Rear Feed
Rear Feed Emulation Mode
Print Mode
DRAFT Mode
Pitch
Proportional Spacing
Style
Size
Character Set
Language Set
Zero Character
Code Page
Line Spacing
Form Tear-off
IBM PPR
Utility
HSD
10 CPI
No
Normal
Single
Set 1
American
Slashed
USA
6 LPI
Off
0596-0317-01 Rev. A Page 6