Hangar 9 Twist 60 ARF - Manual (Page 8)

8
Required Parts
•.Wing.panel.w/ailerons
•.Servo.w/hardware.(2)
•.Servo.extension,.9".(228mm).(2)
•.Pre-assembled.3
.
1 /
2
".(89mm).aileron.linkage.(2)
Required Tools and Adhesives
•.Drill. •.Thin.CA
•.Drill.bit:.1/16".(1.5mm),.5/64".(2mm)
•.Phillips.screwdriver.
•.Long.servo.arm
 .  .Step 1
Check.to.make.sure.the.hinges.have.been.securely.glued.
into.place..Gently.pull.on.each.aileron.to.make.sure.the.
hinges.are.secure..Avoid.too.much.pressure.which.could.
cause.damage.to.the.wing.and.aileron..Saturate.each.
hinge.if.you.find.any.that.are.loose.
 .  .Step 2
Flex.each.aileron.up.and.down.a.number.of.times.to..
break.in.the.hinges.
Section 1: Aileron Servo Installation