Hangar 9 Twist 60 ARF - Manual (Page 18)

18
 .Step 4
Build.a.wiring.harness.for.the.batteries.using.a.female.
connector.and.two.male.connectors..Follow.the.wiring..
in.the.photo.so.the.motor.sees.the.voltage.increase.of..
the.two.batteries.
 .Step 5
Solder.the.appropriate.connectors.onto.the.speed.control.
Note:.If.you.only.plan.on.using.this.controller.
in.your.Twist™,.you.can.combine.Steps.4.
and.5.by.incorporating.the.harness.with.the.
speed.control.so.the.controller.is.positioned.
in.place.of.the.single.female.connector.
 .Step 6
Prepare.the.front.and.rear.battery.trays.by.routing.the.hook.
and.loop.straps.through.the.trays.
 .Step 7
Use.6-minute.epoxy.to.glue.the.front.and.rear.battery.
tray.into.the.fuselage..The.rear.tray.has.a.tab.that.will.key.
into.the.former,.while.the.front.tray.fits.flush.against.the.
backside.of.the.firewall.
 .Step 8
Remove.the.covering.from.the.bottom.of.the.fuselage.to.
allow.for.cooling.air.through.the.fuselage.
Section 3B: Electric Motor Installation