Hangar 9 Twist 60 ARF - Manual (Page 20)

20
Required Parts
•.Fuselage. •.Wing
•.1/4-20.x.1
.
1 /
2
".nylon.bolt.(2)
•.Canopy
Required Tools and Adhesives
•.Canopy.glue. •.Flat.screwdriver
•.Felt-tipped.pen. •.Masking.tape
•.1/4".foam
 .Step 1
Wrap.the.receiver.and.receiver.battery.in.1/4".foam.to.
protect.them.from.vibration.
 .Step 2
Plug.the.throttle,.elevator.and.rudder.servo.leads,.as.well.
as.the.switch.harness,.into.the.receiver..Route.the.receiver.
antenna.to.the.rear.of.the.fuselage..A.tube.has.been.pre-
installed.for.routing.the.receiver.antenna.wire.
 .Step 3
Place.the.receiver.and.receiver.battery.into.the.fuselage..
Use.epoxy.mixing.stick.to.make.braces.inside.the.fuselage.
to.prevent.the.receiver.and.receiver.battery.from.shifting.
during.flight.
Note:.When.using.an.electrick.motor.and.
a.smaller.270.mAh.pack,.you.can.place.the.
pack.underneath.the.throttle.servo.tray.to.
provide.for.more.room.for.the.motor.batteries.
 .Step 4
Mount.the.switch.harness.in.the.side.of.the.fuselage..The.
switch.should.be.on.the.opposite.side.of.the.muffler.when.
using.a.glow.engine.
Section 4: Final Assembly