Hangar 9 Twist 60 ARF - Manual (Page 13)

13
Required Parts
•.Fuselage. •.Engine.mount.(2)
•.8-32.x.1".screw.(4). •#8.washer.(4)
•.Rubber.band.(2). •.Pushrod.connector
•.8-32.locknut.(4). •.8-32.blind.nut.(4)
•.8-32.x.1
.
1 /
4
".screw.(4)
•.14
.
1 /
2
".(370mm).pushrod.tube
•.16
.
1 /
2
".(420mm).throttle.pushrod
•.2
.
1 /
2
".(64mm).spinner.w/hardware
•.Pushrod.connector.backplate
•.3mm.x.5mm.machine.screw
Required Tools and Adhesives
•.Servo.w/hardware. •.Ruler
•.Drill. •.Phillips.screwdriver
•.Hobby.knife
•.Drill.bit:.1/16".(1.5mm),.5/64".(2mm),.5/32".(4mm)
 .Step 1
Mount.the.engine.mount.onto.the.firewall.using.four..
8-32.x.1".screws.and.four.8-32.blind.nuts.
Note:.Use.the.outer.holes.for.
mounting.the.engine.mount.
 .Step 2
Position.the.engine.on.the.engine.mount.so.the.drive.
washer.is.5".(127mm).ahead.of.the.firewall..Mark.the.
location.of.the.engine.mounting.bolts.using.a.felt-tipped.
pen..Use.a.5/32".(4mm).drill.bit.to.drill.the.holes.in.the.
engine.mount.
Hint:.Use.a.drill.press.to.get.the.holes.in.
the.mount.perpendicular.to.the.mount.
Section 3A: Two-Stroke Engine Installation