Hangar 9 33% Pawnee 80cc ARF (3 Boxes) - Manual (Page 18)

18 Hangar 9 33% Pawnee 80cc ARF
1 1 /
4
-inch
(31mm)
 3. There is a right and left stabilizer and elevator
assembly. When installing them, make sure the countersunk
hole for the elevator control horn screw faces toward the top
of the airframe.
 4. Slide the aluminum tubes for the stabilizer into the
stabilizer. Note the longer tube is closer to the elevator as
shown in the photo below.
 5. Slide the stabilizer assembly into the slot at the rear of
the fuselage.
Note : Always use threadlock on metal-to-metal
fasteners to prevent them from vibrating loose.
 6. Use two 8-32 x 1 1 /
4
-inch socket head cap screws and
two #8 washers to keep the stabilizer half in position. Do not
tighten the screws at this time.
 7. Slide the remaining stabilizer into position. Start the
screws that secure the stabilizer. Once all the screws have
been started, use a 1/8-inch hex wrench to fully tighten the
screws, securing the stabilizer to the fuselage.