Hangar 9 Twist 40 ARF Version 2 - Manual (Page 3)

4 5
Field Equipment Required
Propeller (2-stroke (EVO11050) 4-stroke (EVO13080)) • Glow Plug Igniter with Charger (HAN7101) •
Fuel • Glow Plug (EVOGP1/HAN3011) •
Glow Plug Wrench (HAN2510) • Manual Fuel Pump (HAN118) •
12-Volt Starter (HAN162) •
Additional Required Tools and Adhesives
Tools: Adhesives:
Canopy scissors • 6-minute epoxy (PAAPT38) •
Drill • 30-minute epoxy (PAAPT39) •
Drill bits: 1/16-inch, 3/32-inch, 1/8-inch, 9/64-inch, 5/32-inch • Thin CA (PAAPT07) •
Felt-tipped pen • Medium CA (PAAPT01) •
Flat blade screwdriver • CA remover/debonder (PAAPT16) •
Foam: 1/2-inch • Masking tape (MMM20901) •
Hobby knife • Canopy glue (Formula 560) •
Making tape • Other Required Items:
Paper towels • 2 ¼-inch spinner (Red, DUB280) •
Petroleum jelly • Epoxy brushes (DUB345) •
Phillips screwdriver (large) • File •
Phillips screwdriver (small) • Measuring device (e.g. ruler, tape measure) •
Pliers • Mixing sticks for epoxy (DUB346) •
Rubbing alcohol • Paper towels •
Ruler • Rubbing alcohol •
Sandpaper • Wax paper •
Soldering iron •
Square •
T-pins •
Warning
An RC aircraft is not a toy. If misused, it can cause serious bodily harm and damage to property. Fly only in open areas, perferably
at AMA (Academy of Model Aeronautics) approved flying sites, following all instructions included with your radio and engine.
Age Recommendation: 14 years or over. Not a toy. Not intended for use by children without direct adult supervision.
Before Starting Assembly
Before beginning the assembly of your Twist, remove each part from its bag for inspection. Closely inspect the fuselage, wing
panels, rudder, and stabilizer for damage. If you find any damaged or missing parts, contact the place of purchase.
If you find any wrinkles in the covering, use a heat gun or covering iron to remove them. Use caution while working around areas
where the colors overlap to prevent separating the colors.
HAN100 – Heat Gun HAN135 – Pro-Seal
Covering Iron
Using the Manual
This manual is divided into sections to help make assembly easier to understand and to provide breaks between each major
section. In addition, check boxes have been placed next to each step to keep track of each step completed. Steps with two boxes
indicate the step will require repeating, such as for a right or left wing panel, two servos, etc. Remember to take your time and
follow the directions.