FRITSCH PULVERISETTE 9 - Manual (Page 26)

CAUTION!
Burn hazard!
The grinding bowl can become hot during long grinding
periods. Allow for cooling time after grinding.
Wear safety gloves!
6.1.5 Filling the grinding set
Filling quantity maximum as specified useable volumes (50, 100 or 250
ml).
Filling quantity minimum 30 % of specified useable volumes.
1.
Place all grinding bodies with the rounded edge downwards in the
empty grinding cup.
2. Fill grinding stock into the grinding cup between the grinding
bodies.
3. Clean grinding stock from the edge of the grinding cup if neces-
sary; clean seal ring in the lid.
4. Put on the lid.
6.1.6 Clamping the grinding set
Check the entire clamping device and the clamp lever for tight fit before
every grinding.
1. Insert the filled grinding set in the front of the mounting and turn
if necessary until it is seated properly in the gap so that it cannot
turn. Push the lever all the way back.
2. Take hold of the grinding set by the grips at the front and push all
the way back under the eccentric tensioning roller (2).
Inserting
Using the device
- 26 -