Doepfer MTC64 Relay Board - Manual (Page 2)

• The pc boards has 3 mm mounting holes that can be used to mount the
board to the bottom of the case with screws, washers, nuts and spacers. If a
plastic case is used even plastic screws/washers/nuts/spacers have to be
used. In case of metallic screws/washers/nuts dangerous voltages may
appear at these parts outside the plastic case. If a (grounded) metallic case
is used even metallic screws/washers/nuts/spacers are allowed.
• The MTC64 main board has to be adjusted to the desired Midi channel, note
number range (resp. program change number range), mode (note or
program change) and polarity before the case that contains both MTC relay
board(s) and the corresponding main board is closed. Please refer to the
user's manual of MTC64 main board for details.
• If the outputs of the MTC relay board behave the other way round the
polarity of the MTC64 outputs have to be changed.
• The MTC64 Relay Board may only be used for the purpose described in this
operating manual. Due to safety reasons, the device must never be used for
other purposes not described in this manual. If you are not sure about the
intended purpose of the instrument please contact an expert.