Cisco 3032 - Manual (Page 29)

29
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
OL-14317-01
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
Accessing Help Online
Resetting the Switch Configuration
This section describes how to reset the switch configuration by rerunning the
initial configuration dialog (System Configuration Dialog). These are reasons
why you might want to reset the switch:
• You installed the switch in your network and cannot connect to it because you
assigned the wrong IP address.
• You want to clear the configuration from the switch and assign a new IP
address.
Caution Resetting the switch deletes the configuration and reboots the switch.
To reset the switch:
• At the switch prompt, enter enable and press Return or Enter.
• At the privileged EXEC prompt ( switch# ) enter setup, and press
Return or Enter.
The switch displays the prompt to run the initial configuration dialog. See the
“Configuring the Switch” section on page 12 to re-enter the configuration
information and to set up your switch.
Accessing Help Online
For a solution to your problem, look in the troubleshooting section of the
hardware installation guide or the software configuration guide on Cisco.com.
You can also access the Cisco Technical Support and Documentation website for
a list of known hardware problems and extensive troubleshooting documentation.