Cisco 3032 - Manual (Page 16)

Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
Configuring the Switch
16
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
OL-14317-01
Step 4 Make sure that the System Status/ID LED on the switch is off. This means that
the switch is operating properly.
Step 5 See the “Completing the Initial Configuration” section on page 16 for instructions
on setting up and initially configuring the switch.
Completing the Initial Configuration
Follow these steps to complete the setup program and to create an initial
configuration for the switch.
Note For information about automatically configuring the switch, see the “Assigning
the Switch IP Address and Default Gateway” chapter in the switch
configuration guide on Cisco.com.
Step 1 After you have pressed Enter or Return after the prompt to start the initial
configuration setup program, enter yes at these prompts:
Would you like to terminate autoinstall? [yes]: yes
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Configuring global parameters:
Step 2 Enter a hostname for the switch after the prompt, and press Return.
The hostname is limited to 20 characters. Do not use -n, where n is a number, as
the last character in a host name for any switch.