Cub Cadet Series C470 - Manual (Page 20)

20
WARNING
Servicing
Your
Utility
Vehicle
Figure 13
Figure 12
,UBE
Rear Knuckle Lubrication
1. Lubricate two grease fittings on each knuckle with 2
or 3 shots of grease every 50 hours or after each use
if consistently running unit in water deeper than axle.
See Figure 12.
Changing Brake Pads
WARNING: Using an unstable lifting
device and vehicle support may result
in bodily injury. Use a safe lifting
device and supports to work on raised
vehicle.
To gain access to the brake pads, remove the wheel as
described in the
Wheel Replacement Section. If less
than .030” of material remains on the pad, replace.
NOTE: Brake pads must be replaced as a set, ie., right
rear and left rear.
To change the brake pads, follow the steps below and
refer to Figure 13.
1. Remove clips at the end of the mounting bolts.
2. Remove mounting bolts securing caliper and brake
pads to mounting bracket.
3. Remove brake pads from caliper and replace with new
pads.
4. Press in brake piston and place caliper and new brake
pads into place in the mounting bracket, making sure
brake disc is between the two brake pads.
IMPORTANT: When pressing in brake piston, take care
not to damage rubber piston seal.
5. Secure caliper and brake pads to mounting bracket
with mounting bolts and clips removed earlier. Torque
the mounting bolts to 32 to 36 ft. lbs.
6. Replace wheel as described in Wheel Replacement
section.
Using an unstable lift-
ing device and vehicle
support may result in
bodily injury. Use a
safe lifting device and
supports to work on
raised vehicle.