COP-USA DVRC264-4CH_USB User Manual

Page 30

Digital Video Recorder User Manual

Fig 3.7 Record Setup

STEP2

Set Video quality, Frame rate, and Resolution.

STEP3

Have Audio checked if you input audio and want to record. Check Time stamp to record

STEP4

Enable recording function for cameras in Record option.

Notice: If have camera uncheck here, it will not record in any recording mode.

STEP5

Set Alarm record hold time. It is for post alarm recording.

STEP6

Enable Recycle. It covers old video once HDD full. If you have it unchecked, it will stop recording auto once

HDD full
STEP7

Click OK to finish

Notice: The higher the used storage of every hour, the higher the value of Video quality, Frame rate and Resolution.

This Unit supports pre-alarm recording. But no option to set the pre-alarm recording time, the default is 10 seconds

3.3.2 Manual Recording

Just press REC button on the front panel after quitting system setup. Press Stop button to stop recording.
Or press REC button on remote controller, click again to stop.

This manual is related to the following products:

DVRC264-4MEDVD