COP-USA DVRC264-4CH_USB - Manual (Page 134)

Digital Video Recorder User Manual
5
contrast below figure and the entity for realizing the function of every interface.
The Back Panel and interface terminal is shown as Fig2.2 Back Panel.
1 Power plug 2 Alarm in/alarm out
3 RS485 4 LAN port
5 Audio in 1-2 6 S-video output
7 Audio output 8 Video output
9 Video in 1-4
Fig2.2 Back Panel
2.4 Remote Controller Introduction
2.4.1 Use Remote Controller
Notice: Please note that Remote Controller is not a standard part of this DVR. Your package might not include it.
Steps of using the Remote Controller are described as below:
STEP1 Put the battery into the Remote Controller.
1. Open the battery cover of the Remote Controller.
2. Put into two AAA batteries whose model is 7 and make sure that they are not inserted upside down.
3. Put back the battery cover.
STEP2 Check the followings if the Remote Controller does not work.
Whether the battery’s anode and cathode are in the correct position or not.
Whether the power of the battery is ran out or not.
Whether there is barrier between the Remote Controller and DVR or not.