COP-USA NVR2816NE-L - Manual (Page 29)

NVR User Manual
23
5.3 Record Configuration
Record configuration includes five sub menus: enable, record bit rate, time, stamp and recycle record.
5.3.1 Enable
Step1: Enter into MenuSetupRecordEnable tab. Refer to Fig 5-10:
Fig 5-10 Record Configuration-Enable
Step2: Checkmark record and audio.
Step3: Select All to setup the same settings for all channels.
5.3.2 Record Bitrate
Step1: Enter into MenuSetupRecordRecord Bitrate interface. Refer to Fig 5-11:
Step2: Setup rate, resolution, quality, encode and max bit stream
Step3: Select “All” to set the same settings for all channels.
Step4: Click “Default” button to restore default setting; click “Apply” button to save the setting; click “Exit” button to exit the
current interface.
Note: If the rate value set is beyond the available resources of the device, the value will be adjusted automatically.
Parameter Meaning
Record To enable/disable recording
for the channel
Audio To enable/disable audio
recording for the channel