COP-USA ASH56NVIR-L36S - Manual (Page 13)

11
V. Installation of the Product
5.1 Drawing of the Sizes of the Product
Outline Sizes of the Pan/Tilt
5.2 Installation Style of the Product
A. Installation Style of Plain Base
350
260
70
18
0
Drawing of Sizes of the Side Drawing of Sizes of the Bottom
5.3 Installation Procedures of the Product
1. Remove the bottom plate of the pan/tilt;
2. Set the corresponding information in accordance with the schematic drawing of the dip-switch of
addresses, protocols and baud rates;
3. Install the bottom plate of the pan/tilt and take care of the tightness of waterproof seal ring;