COP-USA CD55HD - Manual (Page 4)

Operation Manual for Intelligent Speed Dome Camera
3
Principle: we call “hard ID (HID)” that setting by the Dip-switcher, and “Soft ID
(SID) that setting by the Long-distance address modify. The HID and the SID are
same in leaving factory. For example: Camera No.001, HID=SID=001, we change
the SID=002 by RS485, so we should select the No. 002 to control it, and the SID
address will be remember after shut. And if we change the HID=003 by Dip-switcher,
the HID and the SID will be both change to HID=SID=003
4. Functions of the Camera
a. Description of the Focus Control Mode: the user can adjust the focus of the camera
manually. When the camera is on near focus, the icon appears on the screen;
when on the nearest state, the icon appears while on the far focus, the icon
appears.
b. Description of Backlight Compensation: when the object to be shot is dark and
looks dim, the user can open the backlight compensation according to actual need. and
the icon appears on the screen.
c. Description of White Balance: when the image has color distort on the screen, the
user can set different modes by orders. There are 6modes for options: Indoor Mode
Outdoor Mode Touch Mode Automatic Trace of White Balance
ATW Manual WB-MAN Automatic Mode.
d. Description of ZOOM Control: user can “pull near” or “push far” the lens according
to actual conditions, and the symbol appears on the screen in which
the front part means optical multiplication while the rear part means digital
multiplication.
e. Electron shutter: it is 1/50 sec after the camera electrified, and it will display 50 on the
monitor.
f. AE Mode: setup of Manual/Automatic.
g. Zero Illuminance: It is used only when the external brightness is extremely low.
Normally the camera works on the automatic state. In case the external brightness is
lower than 1Lux, the camera can be switch to the Zero Illuminance state automatically
and icon appears on the screen. You can also set the Zero Illuminance state
manually.
III. Setup of the Menu of the Dome Camera
1. Basic Operation of the Menu
1.1 Open the main menu of the setup by the keyboard or the matrix via the operation “Call
No. 64 preset position or No.95 preset position”. Besides that, continuously call No.1
preset position twice in 4 seconds, you can also open the menu; Through setting No.64
preset position in order to close the munu.
1.2 When the menu is displayed on the screen, operate “TILT UP”, “TILT DOWN” to move
the cursor to the option to be set, operate “PAN LEFT”, “PAN RIGHT” to modify the
content or the order to enter this option.
1.3 All setups on the menu couldn’t be lost even power failure happens.
2. Setup of the Menu
2.1 MAIN MENU
2.1.1 SYSTEM SETUP.