Checkline RH5 - Manual (Page 6)

 Electromatic Equipment Co., Inc.
-6-
4.0 MENU
There are 4 menu levels. The symbols show the key
functions in the different menus.
1. Type selection:
2. Saving:
3. Additional le vel:
Rolling Menu: Use this key to enter the different
menu levels and main menu.
Power: Press this key for to switch the instrument
off (5 sec.) or on (3 sec.). Press this key briefly to
activate the display lighting.
Up: This key moves you to the next type/calibration
curve.
Down: This key moves you to the previous
type/calibration curve.
Disk: Use this key to save measurement values.
If this symbol and a number are beside the disk
symbol an AutoLog series is started.
If only a number is shown in front of the disk symbol the
measurement value can be saved manually (manual
log). Zero means that the number of values saved at that
time is zero.
Alternatively: Hold: The currently shown
measurement value is held. It is released when another
key is pressed.
View logs: If no logs are active (the last
measuring series has been completed), you can use this
symbol to view the saved measuring series.
Alternatively: Edit logs: If logs are active (the current
measuring series is not yet completed), you can press
this symbol and then enter e.g. batch number and
supplier’s data for the series.
Edit type: Needed to calibrate user-defined
calibration curves
In the additional level, press (Rolling Menu) to enter
the main menu.
4. Main menu
Edit Logs
Manual Logs
Auto Logs
Clear Logs
Print Logs
Last Logs
All Logs
Clear Logs
Send Logs
Manual Logs
Auto Logs
Clear Logs
Options
Date / Time
Log Time
Language
Unlock
°C / °F
Userlevel
BL On Time
Auto Off Time
Calibrate
Materialcalib.
Password
Reset
Status
 Electromatic Equipment Co., Inc.
-11-
10.0 CHANGING THE BATTERIES
Batteries are supplied in the instrument when delivered.
Changing the batteries:
Use a finger to press the arrow on the battery cover and
pull it back.
Remove the flat batteries and replace them with four
new 1.5 Volt AA Alkaline Batteries. Make sure you place
the battery poles in the right positions.
Press the batteries down so you can close the cover.
11.0
LIABILITY
The manufacturer is not liable for any incorrect measurements and resulting
damages.
As this rapid measurement procedure is influenced by product-specific and
application-specific conditions, we recommend you carry out a plausibility check on
the measurement results. Each instrument has a serial number and warranty seal. If
this is broken we cannot provide warranty. If the instrument is defective, contact
Electromatic via www.checkline.com.
12.0 OPTIONAL ACCESSORIES
Wall holder / table stand Two-in-one holder for the RHx instrument series made of
acrylic glass.
Interface for printing saved data on a portable printer and/or transferring data to a
PC incl. Software humimeter LogMemorizer
Humimeter LogMemorizer data recording and analysis software for Windows®
PCs based on a database; for recording data, direct analysis of measurement
values in the program, numerous export functions.
Portable measurement value printer – Battery-powered direct thermal printer
Sword cover for RH5 to protect the sword-shaped sensor for use with heavy
stacks.
Sword cover remover for RH5 for removing the sword cover from heavy stacks.
Checking unit and humidity standards: For checking your own RHx humimeter.