Checkline RX-DD - Manual (Page 2)

ELECTROMATIC Equipment Co., Inc.
‐2‐
HOLD
To Activate Hold: Press and release HOLD
To Turn Hold On/Off: Press and release HOLD
TOLERANCING (High / Low Limits)
To Set Tolerance Numbers:
- Press and hold TOL until HIGH is flashing
- Press 2 ND
- Press TOL
- Press CHANGE
- Press MOVE until the +/- sign or digit to be set is blinking.
- Press CHANGE to reverse the +/- sign or increment the blinking
digit.
- Repeat MOVE and CHANGE until desired # is entered
(press ON/clr to clear).
- Press Apply to save
After step is completed, LOW will automatically start flashing.
- Repeat above steps to set low tolerance
To Turn Tolerances On/Off: Press TOL
ELECTROMATIC Equipment Co., Inc.
‐3‐
NOTE! “TOL” will show on display when no tolerances have been
set.
TOTAL RESET
To Clear All Settings and Return To Factory Set Defaults:
- Press 2
ND
Appears on top of display
- Press ON/clr
- Press IN/MM
NOTE! Total reset cannot be accomplished if lock feature is on.
FEATURE LOCK
To Turn Feature Lock Feature On/Off:
- Press 2
ND
Appears on top of display
- Press ON/clr
- Press TOL
NOTE! A key will appear on the bottom left side of display when
features are locked.
POWER
The durometer uses two internal batteries or an external AC
adapter.