Checkline PT-200 User Manual

Page 18

Returning for Service

Before returning the Gage for service…

1.Install new Alkaline batteries in the proper

alignment as shown within battery compartment.

2.Examine the probe tip for dirt or damage.

3.Perform a Reset (pg.11) and a Zero (pg.5)

4.Place a plastic shim onto a hard surface (i.e. glass)

and attempt a measurement. (see pg.5)

If you must return the Gage for service, describe the
problem fully and include measurement results, if
any. Be sure to also include the gage, probe, your
company name, company contact, telephone
number and fax number or email address.

Website: www.CHECKLINE.com

Changing The Batteries

The battery icon displays a full bar with fresh
alkaline batteries installed. As the batteries weaken,
the bar will be reduced. When the battery icon is low

, the Gage can still be used, but the batteries

should be changed at the earliest opportunity. USE
ONLY “AAA” ALKALINE BATTERIES. Nickel-cadmium and
nickel-metal hydride rechargeable batteries will work
but the Gage may appear to have weak batteries.

To retain all user settings and stored memory read-
ings, only replace the batteries after the Gage has
automatically powered-down.

echnical Dat

Conforms to: ASTM D6132 and ISO 2808

Gage body dimensions:
(146 x 64 x 31 mm) 5.75" x 2.5" x 1.2"

Temperature Range: 0 to 40°C (+32° to +104°F)