Checkline TI-25DL User Manual

Page 3

– 3 –

3.0

VERVIEW

AUGE

3.1 Gauge

Probe

Receptacles

Red LED

Green LED

Probe Zero Test Plate

(battery compartment cover)

Serial Output
Port

Backlit LCD
Display

Bottom of Gauge

Probe

– 34 –

13.0 M

ATERIAL

AFETY

ATA

HEET

(MSDS)

Section 1— Product Identification

Product Name: TI-25DL

Generic Name: Ultrasonic Couplant

Manufacturer: Electromatic Equpt. Co.

NFPA Hazardous Materials Identification System (est)
Health 0 Flammability 0 Reactivity 0

Section 2— Hazardous Ingredients

This material does not contain any ingredients having known health hazards in concentrations
greater than 1%. This material does not contain any known or suspected carcinogens.

Section 3 — Physical Data (nominal)

Boiling Point: >220°F

Freezing Point: <20°F

Vapor Pressure: N/A

Evaporation Rate: N/A

Specific Gravity: >1.0Z

Solubility in Water: complete

pH: 7.35 – 7.9

Acoustic Imp.: 1.726 x 10

Vapor Density: N/A

Appearance and Odor: water white, opaque gel; bland odor

Section 4 — Fire and Explosive Hazard Data

Flash Point: none Upper Exposure Limit: none Lower Exposure Limit: none
Special Fire Fighting Procedures: N/A

Extinguishing media: N/A

Unusual Fire and Explosion Hazards: none

Section 5 — Reactive Data

Stability: Stable Conditions to Avoid: none
Incompatibility (Materials to Avoid): none known
Hazardous Polymerization: will not occur
Hazardous Decomposition or Byproducts: none known

Section 6 —- Health Hazard and First Aid Data

Routes of Entry

Skin: not likely Ingestion: not normally

Eyes: not normally

Inhalation: no

Effects of Overexposure:

Acute: May cause temporary eye irritation

Chronic: none expected

First Aid Procedures:

Skin: Remove with water if desired.

Eyes: Flush with water for 15 minutes.

Ingestion: For large quantities, induce vomiting and call a physician Inhalation: N/A

Section 7 - Storage and Handling Information

Precautions to be taken in handling and storage: Store between 20 °F and 120 °F. Spills are
slippery and should be cleaned up immediately. Steps to be taken in case material is released or
spilled: Pick up excess for disposal. Clean with water. Waste disposal method: Dispose of in
accordance with federal, state, and local regulations.

Section 8 — Control Measures

Respiratory Protection: not required

Ventilation: not required

Protective Gloves: on individuals demonstrating sensitivity to TI-25
Eye Protection: as required by working conditions

Other Protective Equipment: not required

1. TI-25DL contains only food grade and cosmetic grade ingredients.

Membrane
Keypad