Checkline DT-207LR - Manual (Page 4)

– 4 –
3.0 CONTENTS OF COMPLETE KIT
A. Tachometer
B. 6-inch Suface Speed Wheel (modelsDT-205LR,DT207LR)
12-inch Suface Speed Wheel (modelsDT-205LR-12,DT207LR-12)
C. Batteries (2 pcs. x AA)
D. Cone Tip Adapter
E. Screw-In Contact Adaptor (DT-ADP-200LR)
F. Reflective Tape
G. Carrying Case
Not shown — Instruction manual stored behind foam
B
D
F
C
A
G
E
– 9 –
8.0 BUILT-IN MEMORY SYSTEM
The DT-205LR, DT-207LR,DT-205LR-12 and DT-207LR-12 include an
automatic built-in memory system capable of storing the Last, Maximum
and Minimum readings for recall to the display. These values are stored
automatically and there is no need to press any buttons to store data.
Note:
• When utilizing the Length Measurement functions, only the Last reading
is retained in the display.
• The stored data will be deleted when the Tachometer automatically
powers off.
Recall Stored Readings
To recall stored readings to the display, press the Memory Switch. A stored
value will alternately flash on the display along with the memory location
number (1, 2 ...10).
Clearing Stored Readings (Memory Clearing)
To clear the memory (for all functions), press the memory switch for
approximately 5 seconds until the display shows “CCCCCC.” Next, press
the white Power switch or Memory switch. This resets the tachometer for
use.