California Faucets Solima Roman Set and Handshower with Trim User Manual
Page 2
7008_ii_140505.doc
Pg 2
2
3
4
INSTALLING VALVE
Tub/Deck recommended hole size shall be Ø1-1/4”
From underside insert
VALVE (7) though
appropriate tub/deck hole
IMPORTANT: VALVES (7) are labeled as follows:
BLUE
is
COLD
left turning (counter-clockwise) closed
RED
is
HOT
right-turning (clockwise) closed
Position flange NUT (7b) and WASHER (7a) so
that VALVE (7) extends 1-3/8” above tub/deck
surface
Insert O-RING (3) into ESCUTCHEON (8) and
place onto VALVE (7)
Secure ESCUTCHEON (8) onto tub/deck by
tightening lock NUT (9)
ALIGNMENT OF BASES
Use a ruler or straight edge to align the spout base
and escutcheons of the faucet as shown
After alignment retighten lock nuts and spout nut
INSTALLING HANDLE
Loosen SETSCREW (10a) from HANDLE (10)
IMPORTANT: Handle BLADE (10b) shall be aligned with wider
portion of handle POST (10c)
Slide HANDLE (10) down onto and engage valve
STEM (7a)
Handle POST (10c) shall completely cover lock
NUT (9) and seat against ESCUTCHEON (8)
Tighten SETSCREW (10a) and rotate handle
BLADE (10b) to check operation, open position is
when BLADE (10b) is rotated forward
To obtain proper alignment it may be necessary to
rotate VALVE (7) so that handle BLADE (10b) is
aligned with SPOUT (1). This may be achieved as
follows:
Slightly loosen lock NUT (9)
Place HANDLE (10) onto valve STEM (7a)
Rotate VALVE (7) in proper direction to achieve
proper alignment of handle BLADE (10b)
Remove HANDLE (10) and while firmly holding
VALVE (7) in position from underneath securely
tighten lock NUT (9)
Then reattached HANDLE (10) as mentioned
above
1-3/8”
Ш
1-1/4”