California Faucets Contemporary Floor Mount Tub Filler - Manual (Page 2)

1103-XX_ii_140625 Pg 2
2
3
INSTALLING QUICK CONNECT
 Apply Teflon ® TAPE (11) (not supplied) onto both
ends on ½” NPT (10) nipple (not supplied)
 Insert ½” NPT (10) nipple into quick CONNECT
(12) first and then using ½” drive RATCHET (17)
tighten assembly into NIPPLE (4) in flooring rough
Important: It is the responsibility of the INSTALLER to select the
necessary length of ½” NPT (10) nipples to determine proper
finished height (7/8” to 1-5/8”) of the quick CONNECT (12).
PREPARING LEGS
Important: It is the responsibility of the INSTALLER to discuss
with CONSUMER as to which side the HANDSHOWER (21) shall
be placed on the Floor Mounted Tub Filler before proceeding.
 Onto each LEG (15) slide tie down NUT (13) and
COVER (14)
 LEG (15) without handshower place SPACER (19) at
top of LEG (15)
 LEG (15) with handshower place friction WASHER
(16), then HOOK (18) and second friction
WASHER (16) on top of LEG (15) (HOOK shall
have one friction WASHER on top and bottom)
Important: Proper orientation of the HOOK (18) is necessary to
properly allow HANDSHOWER (21) to fit into HOOK (18) before
proceeding.
 Attach CONICIAL (20a) nut of HOSE (20) to
HANDSHOWER (21) to confirm proper
orientation of the HOOK (18) as shown below
HOT
supply
COLD
supply
TUB
location
Finished QC Height
7/8” to 1-5/8 ”