California Faucets 1/2" Pressure Balance Valve Tirim - Manual (Page 4)

TO-PBL-XX_ii_110112.doc Pg 4
4
FINISH CARE
See complete finish care instructions at www.calfaucets.com
• Wipe dry after each use with a soft dry cloth to prevent water-spotting and mineral build-up
• Clean and wax regularly
o
For Living Finishes (e.g. Weathered Brass, Weathered Copper, Oil Rubbed Bronze, Rustico Bronze) we recommend Renaissance
Wax
o
For all other finishes, we recommend Faucet Brite, which contains both gentle cleansers and a fine wax coating. Otherwise, clean
with mild soap and water, then apply a quality car wax or floor paste wax
• Avoid all abrasive and aggressive chemicals (e.g. Soft Scrub®)
• Do not use abrasive cleaning pads (e.g. Scotch-Brite ®)
• Avoid ammoniated products (e.g. window cleaner, tile cleaners, etc.)
• Avoid bleach
• Do not allow water to come into prolonged contact with faucet surface, wipe down after each use
Failure to follow these care instructions may result in damage to product finish and void warranty.
Please read these instructions, fill in blanks below, and then give these
instructions to the end user.
WARNING: Risk of Scalding
This valve MUST have the TEMPERATURE SETTING verified during
installations. The INSTALLER is responsible for installing the valve
and setting of water temperature in accordance with these
instructions.
THIS PRESSURE BALANCE VALVE HAS BEEN PRESET
BY
OF
TO A MAXIMUM DISCHARGE TEMPERATURE OF
°
F.
ANY CHANGES TO THIS SETTING MAY INCREASE THE
DISCHARGE TEMPERATURE AND COULD RISK SCALDING OF
END USER.
DATE
CAUTION: Danger of scald injury. Valve can be set to
provide highest possible water temperature as supplied by water
heater. The valve temperature must be set by installer to provide
desired user comfort levels as well as meet all local plumbing code
requirements. The responsibility for the proper installation and high
limit temperature setting of this valve lies with the installer.
www.calfaucets.com
5231 Argosy Ave. Huntington Beach, CA 92649
800-822-8855
IMPORTANT: Instructions to the Installer