BUCHI Scrubber K-415 - Manual (Page 35)

5 Putting into operation
35 K-415 Operation Manual, Version B
5 .7 .4 Hose connections for the QuadScrub ECO
The QuadScrub ECO consists of the neutralization, the adsorption vessel, the condenser, the cooling
water control and the reaction stage.
To establish the hose connections, proceed as follows:
• Put hose connectors GL 14 with seals on all PTFE hoses.
• Connect the emission source to the condenser inlet
i
.
• Connect the condenser outlet
j
to the neutralization vessel
a
.
• Connect the adsorption vessel
b
to the top of the reaction tubelet
c
.
• Connect the reaction tubelet (connection on the side
d
) to the bypass valve
g
.
• Connect your cooling water source to the cooling water tube of the water control
e
using the
provided adapter with sieve and tighten it (see chapter 5.6).
• Cut off a piece of the provided silicone hose and connect the cooling water outlet
f
of the water
control
e
to the cooling water inlet
k
of the condenser
m
. Secure both connections with a hose clamp.
• Cut off a piece of the provided silicone hose and connect the cooling water outlet
l
of the
condenser
m
to the waste water system.
3
6
7
4
5
9
8
11
1
2
10
13
12
a Neutralization stage
b Adsorption vessel
c Reaction stage (upper port)
d Reaction stage (side port)
e Water control
f Water control (outlet)
g Bypass valve h Silencer
i Inlet from emission source (digester)
j Outlet to neutralization vessel (top)
k Cooling water inlet of condenser (bottom)
l Cooling water outlet of condenser (top)
m Condenser
Fig. 5.14: Hose connections for QuadScrub ECO