AVF Group NXL4502PB: Cornermount - Manual (Page 13)

DIM “
H
”
MIN 965mm (38")
i
FIG 5
MARK A POINT ON THE WALL (POINT “K”) VERTICALLY ABOVE THE POINT “J”
SHOWN IN FIG 5 (POINT “J” IS WHERE THE TEMPLATE TOUCHES THE WALL)
ENSURE POINT “K” IS DIMENSION “H” ABOVE FLOOR
POINT “K”
MAKE ALLOWANCES FOR SKIRTING/BASE BOARD. ONCE YOU HAVE DECIDED ON THE POSITIONING OF THE UNIT, TAPE
THE TEMPLATES (TP
1
), (TP
2
) & (TP
3
) TOGETHER AND LIFT THEM ABOVE SKIRTING/BASE BOARD WHILE MARKING THE WALL
(ENSURE TEMPLATES REMAIN PARALLEL WITH FLOOR). THIS WILL REMOVE INACCURACIES IN POSITIONING THE WALL
BRACKETS (F) DUE TO THE THICKNESS OF THE SKIRTING/BASE BOARD. THIS IS PARTICULARLY IMPORTANT IF YOU ARE
USING THE TELESCOPIC SUPPORT ARMS ON OR CLOSE TO THEIR MAX OPEN OR MIN CLOSED POSITIONS
DIMENSION “H” MUST BE A MINIMUM OF 965mm (38").
YOU MAY INCREASE THIS DIMENSION IN ORDER TO RAISE
THE TV IF REQUIRED. TO CALCULATE DIMENSION “H” BASED
ON DESIRED SCREEN HEIGHT, PERFORM THE FOLLOWING
CALCULATION: -
1, NOTE THE HEIGHT “L” (SEE FIG 6) ABOVE THE FLOOR YOU
WISH THE UNDERSIDE OF THE TV TO BE
2, MEASURE DIMENSION “M” (SEE FIG 7)
3, ADD “L” TO “M” AND ADD AN ADDITIONAL 370mm
(14½"). THIS WILL GIVE YOU YOUR OPTIMUM DIMENSION
“H”
i.e. L+M+370mm=H
REMEMBER! DIMENSION “H” MUST NOT BE LESS THAN
965mm (38"). IF IT IS THEN ENSURE YOU MAKE DIMENSION
“H” EQUAL TO 965mm (38"). FAILURE TO DO SO WILL
RESULT IN THE SHELF MODULE NOT FITTING
13
DETERMINE WALL BRACKET POSITION 7
FIG 6
DIM “
L”
N
2
FIG 7
DIM “M”
N
1
DIM “M”
UNDERSIDE OF TV
90°
POINT “J”