AVF Group ZML2401: Flat & Tilt TV Mount for ANY WALL - Manual (Page 13)

Rotate your TV so that the guide marks on the hanger are vertical. Next slide your TV down so
that the hanger goes between the two guide tabs on the wall bracket. Ensure the hanger is fully
engaged and rotate clockwise until your TV is level.
If cables from your TV prevent the TV resting against the wall then an alternative hanger
configuration will be required (See Section 17).
If required you can adjust
the level of your TV by
slightly rotating your TV.
I II
III
Removing the TV
This is a two person job. To remove the TV rotate anti-clockwise between 15-30 and lift TV up
and out (ie reverse the movements as shown above).
Guide Tabs
Hanger
Guide Marks
Vertical Line
Hanging The TV 16