acidlab Robokop - Manual (Page 13)

13
The LED of the scale indicates which scale has been selected.
The lowest Scale-LED corresponds to 4/4 time signature.
Shuffle can only be adjusted if 4/4 time signature is selected (i.e. the
lowest LED is illuminated).
Shuffle Programming (Pattern Tap Write Mode)
The Robokop has two kinds of Shuffle:
-
The first kind of shuffle delays the even numbered steps (2, 4, 6, ...).
This is similar to the common shuffle found on the 909.
- The second kind of shuffle delays steps 3, 7, 11 and 15. This second
kind of shuffle is similar to the one on the CR-8000.
Both shuffles can be applied simultaneously.
Each of the two shuffles can be adjusted over a range of 5 degrees.
To do so, press the Inst./Select and the Length/Shuffle buttons at the same
time.
LEDs 1-5 of the step buttons will now indicate the shuffle setting of the first
kind of shuffle.
LEDs 8-12 indicate the shuffle setting of the second kind of shuffle.
Keeping the Inst./Select and Length/Shuffle buttons held, you can now press
the corresponding Step buttons 1-5 or 8-12 to adjust the shuffle.
When shuffle is set to step 1 and step 8, no shuffle is present.
If the scale is changed, the shuffle settings return to the default setting
(no shuffle)!