360 Systems DigiCart/E - Manual (Page 48)

46
• Ethernet Cables
Appendix B
Ethernet Cables
Category 5 Cable and patch cords to be used must meet the TIA/EIA 568-A standard.
The cable used must also comply with local building codes for in-built wiring. This determines the kinds of
insulation that must be used in wiring in various applications. Consult with your network wiring contractor or
local authorities regarding these requirements.
Specifications and Connection Limits for 100-Mbps 100BaseT Transmission
Parameter 100BaseT
Data rate (Mbps) 100
Signaling method Baseband
Maximum segment length 100 m (328 ft) between nodes and hub/repeaters
Media RJ-45: Category 5 UTP
MII: Category 3 4, or 5, 150-ohm UTP or STP, with appropriate
transceiver
Topology Star/Hub
Note RJ-45 cables are not available from 360 Systems. RJ-45 cables are widely available, and must be
Category 5 cables
Straight-through Cable
This cable will work with both 10Base-T and 100Base-TX and is used to connect a network interface card to
a hub or network outlet. These cables are sometimes called "whips".
(RJ45 MALE CONNECTOR To network interface card)
(RJ45 MALE CONNECTOR To hub)