STIEBEL ELTRON SunWarmth CIR 400-2 O - Manual (Page 16)

16 |SUNWARMTH ™ CIR INFRARED HEATER WWW.STIEBEL-ELTRON-USA.COM
INSTALLATION
INSTALLATION
10. Slide cover plates and heater mounting bracket out from top
side of heater. Remove remaining end plate from other end of
heater:
11. Slide face plate out from each end of heater:
12. Remove the heat lamp retainer clip at each end of lamp:
13. The heat lamp is fragile! Carefully side old heat lamp out of
heater through rectangular slot in end of reflector:
» Carefully install new heat lamp and clip in place.
» Reverse steps above to reassemble the heater.
9.8.3 Heat lamp replacement - CIR 400-2 O
1. Compress the width of the protective grill to retract the wire
tabs from under one edge of the heater body.
» Rotate the loose edge of the grill up and away from heater body.
» Pull the grill away from heater to remove from other edge of
heater body - place safety grill in a secure storage container.
» Repeat grill removal for other lamp if required: