OEM Controls Superflex 4 - Manual (Page 9)

file: SF4MAN.DOC - 9 - December 30, 1996
Power
The Superflex System requires a DC
voltage of 10 to 16 volts to operate
properly. This range covers machines
with a nominal 12 volt power source.
Figure 12 shows how connector BT1
connects to power and ground. Be
sure the power wire is of sufficient
size to provide current to the
Superflex and to all of the external
valves connected to the system. The
total system current is not to exceed
12 amps, including all active outputs.
Optimizer
Figure 12 also shows the wiring between Superflex connector BT1
and the Optimizer.
Wiring (Appendix 5)
A wiring diagram, included in appendix 5, gives additional
information on hooking up the input and output signals for your
specific application. Also refer to appendix 4 for the signal names
and BT pin numbers.
Figure 10
Figure 11
Figure 12