Getting started, Connect the aerial, Connect the power plug – Panasonic TX-86W100A User Manual
Page 3: Turn on the television, Getting started connect the aerial
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Connect the Aerial
The RF (Aerial) Input impedance of this television is 750. if your aerial iead is 3000 ribbon (two wires separated
by a flat plastic strip) you will require a 3000/750 Baiun in order to connect your aerial to the television.
To Antenna
i:
TX-86PW100Aa TX-76PW100A
For your safety any externai aerial should be installed by a reputable qualified instaiier and should comply with
Australian Standard AS1417.1.
In New Zealand the installation should comply with International Standard IEC597-1.1.
I
i
Connect the Power Plug
li;
This television is designed for the Australian Standard Mains Voltage of 240V 50Hz and the New Zealand
Standard Mains Voltage of 230V 50Hz.
NOTE;
If the television is not going to be used for an extended period, remove the power piug from the waii outiet.
Turn on the Television
Push the Power Switch to turn the television
ON. Sit back and enjoy your new Panasonic
teievision.