Panasonic TOUGHBOOK CF-50 - Manual (Page 31)

WinDVD ТМ
WinDVD™ (hereafter, WinDVD) is a software application for DVD playback.
Here, you will find explanations and general information on the installation procedure and how to access the online manual.
Installing WinDVD
• Close all other software application before running the Setup program for WinDVD for added safety.
• Log on as the administrator.
's________________________________________________________________________________
(T) Set the WinDVD CD-ROM in the drive.
The WinDVD setup program will run automatically (allow some time for disc recognition). When the setup program will
not run automatically, input [x:\setupj in [Start]* - [Run] and select [OK]. (“x”is the drive letter. You can change the letter
to suit your preference.)
: [start]
Select [Next] at the Welcome Message.
After reading the “License Agreement”*, select [Yes] if you agree to the terms.
* Refer to the “LIMITED USE LICENSE AGREEMENT” on the Operating Instructions of the computer.
@ Follow the on-screen instructions and install WinDVD.
To run WinDVD, it is necessary to make the following settings.
fflwMiimjiiiia Select [Start] - [Settings] - [Control Panel] - [System] - [Hardware] - [Device Manager].
Select [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Man­
ager].
Double-click [Primary IDE Channel] for [IDE ATA/ATAPI controllers].
g Select [Advanced Settings], and confirm that [Transfer Mode] is set to [DMA if available] for [Device 0] and [Device 1].
Double-click [Secondary IDE Channel] for [IDE ATA/ATAPI controllers] and perform as the step .
Running WinDVD
Select [Start] - [Programs] - [InterVideo WinDVD] - [InterVideo WinDVD] or double-click ^ on the desktop.
Select [start] - [All Programs] - [InterVideo WinDVD] - [InterVideo WinDVD] or double-click ^ on the desktop.
Select “?” of the WinDVD control panel.
XNori>
Do not enter the standby or hibernation mode while WinDVD is running.
Do not start WinDVD while the hard disk drive’s access lamp is blinking inunediately after the computer was started up.
If you maximize the video display window, you can return to the original window size by double-clicking over the
images.
During video playback (while the access lamp is on), do not eject the disc.
Do not use other applications or the Command Prompt, and do not change the settings of the screen properties.
In some cases, when the number of colors for the display is increased, a message appears and the DVD cannot be played.
If this happens, reduce the number of display colors.
Immediately after resuming from a pause, frame dropping may occur depending on the operating environment or DVD
video (images or sounds are disrupted).
In the DualView (Dual-Display mode) or simultaneous (intemal/extemal) display mode, there are times when images or
video are not displayed correctly.
During a prolonged period of rapid advance, the pause mode may be established at some point. If this happens, exit
WinDVD, and restart.
31