6\ using the options, A to enjoy hands-free operation, B to operate with a speaker mic – Panasonic PALMLINK KX-TR320B User Manual
Page 7: C for use with a car battery, D carrying case
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

6\ Using the Options
To order, can the accessories
'
teiephone number in section 1-A.
Section 6
6-A To Enjoy Hands-Free Operation
The unit has built-in Voice Activated Transmission (VOX) capability.
Using a Headset Mic (KX-TRA10) or Eartoud Mic (KX-TRA17) with
the unit, you can activate the transmission with your voice.
The unit must be powered off before connection.
The unit enters the VOX mode when the unit is powered ON after
the Headset Mic or the Earbud Mic is connected to the unit.
•“VOX” is displayed.
•To switch to the PTT (Push-To-Talk) mode, press (TALK). To
return to the VOX mode, turn the unit off, then on again.
For details, see the Headset Mic or Earbud Mic operating
radio transmission in the VOX mode.
• You cannot send a message while receiving in the VOX mode.
Wait until the other party stops talking.
• When you finished using the Headset Mic or Earbud Mic. unplug
the Headset Mic or Earbud Mic from the MIC/SP jack to save the
battery life.
To select the receiver volume
The factory preset is “2”.
O Press (3 or El-
m“VOL" and the current volume level will flash on the display.
0 Press El or El repeatedly until the desired volume level
(1-3) is displayed.
To select VOX sensitivity
You can select the VOX sensitivity of the radio to compensate for
varying levels of noise around you. The factory preset is “2"
(Medium).
^
vox
U-
J
O Press (MENU) three times.
•“VOX’ and the current setting will flash on
the display.
0 Press (E) or (E) repeatedly until the
desired setting (1-3) is displayed.
• 1: Low (for high levels of noise)
2: Medium (for use in most applications)
3: High (for low levels of noise)
e
When finished, press [
talk
] or wait for 10 seconds.
ГТ
vox
i
i
о
/
6-B To Operate with a Speaker Mic
Using a Speaker Mic (KX-TRA15) with the unit, you can operate the
unit remotely.
The unit must be powered off before connection.
For details, see the operating instructions for the Speaker Mic.
To MIC/SP
Jack
• When you finished using the Speaker Mic, unplug the Speaker Mic
from the MIC/SP jack to save the battery life.
To select the receiver volume
The factory preset is “5".
O Press (E or El.
•“VOL” and the current volume level wilt flash on the display.
0 Press E) or (E repeatedly until the desired volume level
(1-8) is displayed.
6-C For Use with a Car Battery
If you connect the unit to the cigarette lighter socket of your car
using a Car DC Power Adaptor (KX-TRA20), you can enjoy
transmitting without thinking about the battery life.
The unit must be powered off before connection.
For details, see the operating instructions for the Car DC Power
Adaptor.
• The unit will not run on batteries as long as the DC IN 4.5 V jack is
plugged in.
• Use only Panasonic Car DC Power Adaptor (KX-TRA20). Using
any other car DC power adaptor may cause damage to the unit.
• The Car DC Power Adaptor cannot be used to charge the
rechargeable battery.
6-D Carrying Case
You can hang the unit on your belt or arm using a carrying case
(KX-TRA30).
Carrying Case
(KX-TRA30)