3\ to communicate, A monitor, B sending/receiving messages – Panasonic PALMLINK KX-TR320B User Manual
Page 4: C private talk
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

3\ To Communicate
Backlit LCD Display
The lighted display will remain
on for about 5 secot^ after
pressing any button except
[TAtk] or closing the flip.
Ear Speaker
[TALK]
TALK/BUSY Indicator
Microphone
3-A Monitor
The monitor function activates the speaker. Use this function when
received signals are too weak to recognize. You can use the monitor
function to check activity on the current channel before transmission.
O
Press and hold [ MONITOR ] to open the squelch.
•The TALK/BUSY indicator lights green.
•You will hear static if the channel is clear for use.
0 Release [MONITOR] to close the squelch.
•The TALK/BUSY indicator light goes out.
• If you want to use the monitor privately, open the flip before
pressing [ MONITOR].
3-B Sending/Receiving Messages
O
Check the current channel activity (3-A).
• Do not talk if someone is already on the channel.
@ Press and hold [TAU<] to transmit and talk into the
microphone.
•The TALK/BUSY indicator lights red.
o To receive, release [TALK ].
•The TALK/BUSY indicator lights green.
•Repeat steps 2 and 3 to continue communication.
• To maximize readability of your transmitted signal,
pause a few seconds after pressing [TALK], hold
the unit 2 to 4 inches (5 to 10 cm) from your mouth
and speak at a normal voice level.
• For safe motor vehicle operation, please do not use the unit while
driving. Either stop vehicle or allow passenger to use instead.
To select the main speaker volume
The factory preset is “5".
O Press (^ or C5-
•“VOL' and the current volume level will flash on the display.
© Press or repeatedly until the desired volume level
(1-8) is displayed.
3-C Private Talk
If you want to talk privately during transmission, open the flip. The
unit enters the private talk mode. You can transmit by holding the
unit near your ear like a telephone handset.
O Open the flip and check the current channel activity (3-A).
•“ and “VOX” are displayed.
•Do not talk if someone is already on the channel.
© Press and hold [ TALK ] to transmit and talk into the
microphone.
•The TALK/BUSY indicator lights red.
© To receive, release (TALK].
•You can hear the other party’s voice through the ear speaker.
•The TALK/BUSY indicator lights green.
О When finished, close the flip.
•“ 4'*” and “VOX" will disappear.
• To maximize readability of your transmitted signal, pause a few
seconds after pressing (TALK) and speak.
To select the ear speaker volume
The factory preset is “2".
О
Open the flip and press (3 o’" El-
•“VOL” and the current volume level will flash on the display.
© Press E) oi" ED repeatedly until the desired volume level
(1-3) is displayed.
О
When finished, close the flip.