Panasonic RS-TR272 - Manual (Page 6)

■
o
-SL
_P
DECK1/2
POWER
STANoè^^
OPEN Forward side
DOLBY NR
REVERSE
MODE
< m ^
Tape opening facing downward.
DECKi
F
'■ m -ij. -rt
(► ■ ft
-fl -S 0
DECKfT
~
Ä -20 -t* ~)o -fl -a 0
> R
DECKI T
L lllllllillll■ ltll■ lнn llflf
PLAY «6 -M -ts -n -e -j a
R IlilMlilUlilUlilUII tllll
X-
indicates the side being played.
Type ol tope which cnn be pLivt’d un this unit:
Playback
NORMAL I’OSITION/TVPE I
HIGH POSmON/TYPE 11 ■ '
Metal/TYl’E IV
The unit iiutomLiticallv identifies the type of tape.
The procedures described below nre an example of playback on
Deck 1,
D
Press POWER.
(The unit will switch on.)
Press A OPEN on Deck 1, and then insert the
cassette tape.
Push the cassette holder closed by hand.
To play back on Deck 2, press A OPEN for Deck 2.
Press DOLBY NR to select the appropriate noise-
reduction system.
(Refer to "About the Dolby noise-reduction system" on page
7.)
Each time the button is pressed, the indicator will change in
the order:
b —► C —*■ off.
t_______________ I
Select the same type as that used for recording. When play­
ing back a tape which was not recorded using a Dolby NR
system, press so that the indicators go off.
Press REVERSE MODE to select the appropriate
reverse mode.
(Refer to "Reverse function" on page 7.)
Each time the button is pressed, the indicator will change in
the order:
—► (22} —► OO.
t____________ I
^---- : One side only,
C. 4 _^ : Both sides repeatedly (up to 8 times).
OO ; Both sides, once only.
Press ► (or <).
(Playback will begin.)
► : To begin from the forward side.
4: To begin from the reverse side.
To S t o p playback
Press ■.
To change the Deck to be used
El
Press DECK 1/2 to select the Deck you want to play.
Each time the button is pressed, the indicator will change: DECK 1
DECK 2
(The indicator changes only if a tape is loaded in the other deck.)