Panasonic RS-TR272 - Manual (Page 5)

Connections
lírtoro making coniiL'ctions, in.ikc sum Hint Hin power to this unit
iiiiil ,ill other system components is turned iitf first.
(For areas except Australia and N.Z.)
Use .1 minus (—) screwdriver to set the volt
the voltage setting tor the area in which the unit will be
used.
If the power supply in your area is 115 V or 120 V, please
set the vriltage selector as follows:
I'or 115V: set to 110 V
For 120 V: set to 127 V
Note that this unit will be serit>usly damaged if this setting
is not made correctly.
Amplifier or recewer
This unit
Voltage selector
(For areas except Australia
and N.Z.)
AC power supply cord (included)
Connect this cord after all other cables and
cords are connected.
Household AC outlet
Placements hints
If this unit is placed near a receiver or a tuner, a
"hum" noise may be heard during tape play­
back, recording, or AM reception of the receiver
or the tuner.
If this occurs, leave as much space as possible
between the units, or place them where there is
the least amount of "hum".
Avoid letting the cables touch each other as
much as possible, otherwise noise will be gen­
erated.
(For areas except Australia and N.Z.)
Insertion of Connector
Even when the connector is perfectly insert­
ed, depending on the type of inlet used, the
front part of the connector may jut out as
shown in the drawing.
However there is no problem using the
unit.
Connector
If the power plug will not fit your socket,
use the power plug adaptor (included).
Appliance inlet